Enclosed ground flare fabrication: an illustration of fabricated steel in a workshop
  1. Home
  2. Custom Fabrication
  3. Enclosed Ground Flares
Custom fabrication

Enclosed ground flare fabrication

Enclosed ground flare combustion chambers, wind fences and burner structures for refineries and LNG plants.

Send us a drawing All custom fabrication
What it is

Enclosed Ground Flares, made in India.

An enclosed ground flare burns waste gas inside a refractory-lined steel chamber at ground level, out of sight and with low noise. The chamber, its panels, wind fence and burner supports are large plate structures built to tight tolerances.

Allmarc fabricates to the client’s drawing at our 4 plants in Kanbha, Ahmedabad, with cutting, forming, welding, machining, blasting and painting under one roof.

What we fabricate
  • Combustion chamber shells and panels
  • Lower structures and burner supports
  • Wind fences
  • Platforms, ladders and stairs
  • Trial assembly before shipping
From our work

We fabricated enclosed ground flares for a Louisiana LNG project and for Hazira, India.

See the project

FAQ

Enclosed Ground Flares, answered.

Has Allmarc exported enclosed ground flares?

Yes, for a Louisiana LNG project in the USA, as well as for Hazira in India.

How large are the ground flares you have built?

Four enclosed ground flare systems of about 550 T each, around 20 m across and 46 m high, for a Louisiana LNG project in the USA, and a 50 m high chamber at Hazira, India.

Are ground flares trial-assembled before they ship?

Yes. Each chamber is trial-assembled to full height in our 30 m bay before dispatch, so fit-up problems are found in Ahmedabad, not on site.

Do you do the detail design?

Yes. For Zeeco we did detail design, in-house rolling, CNC profile drilling, painting and in-house assembly.

Do you supply wind fences, platforms and stairs?

Yes. Wind fences, noise shrouds, platforms, ladders and stairs are fabricated with the chamber.

How are chamber panels packed for shipping overseas?

Panels and shell sections are braced, stacked on frames and match-marked after trial assembly, then shipped by sea so they go back together in order.

Which standards do you work to?

ISO 9001:2015, ISO 45001:2018, EN 1090-1 and EN ISO 3834-3, with a Level 2 coating inspector on the floor full time.

How are the panel borders and lower structure drilled?

On our Kotec CNC beam drilling line, which drills heavy profiles on three faces in one pass where plasma cannot give the hole accuracy the bolted joints need.

What finish do ground flare chambers get?

Blasting and painting in our booths, or hot-dip galvanizing, as the project specifies; our scope on the Hazira chamber covered painting and hot-dip galvanizing.

Start a project

Need enclosed ground flares? Send the drawing.

Tell us the quantity, material and delivery; an engineer will reply with how we would make it.

Send us a drawing